Disconnect vent hose from rear of air filter housing. Vacuum line and breather hose from emission control valve (B).Oil tank breather hoses, top and bottom (A).Remove air filter cover and element from air filter housing.Р”Вisconnect emissions/breather hoses at right side of engine compartment. Do not loosen, disconnect or damage A/C refrigerant lines or fittings. Rest compressor on suitable pad.Р”Р„/C refrigerant hoses and components are under high pressure. Swing compressor out of engine compartment onto quarter panel.Tilt compressor to disconnect drive belt from pulley.^ Without loosening or disconnecting A/C lines, remove A/C compressor mounting bolts (arrows). Use tall jack stands to support the vehicle at all four corners. Removal of the engine/transmission assembly will upset the balance of the vehicle. Raise vehicle on lift to a comfortable working height to allow access to top of engine.Р”В«e sure vehicle is stable and fully supported on the manufacturer's lift points. Always wear eye protection when working on or near the battery. Disconnect negative (-) battery cable and cover battery terminal to keep cable from accidentally contacting battery terminal.Р”Р„void getting tools or clothing near the battery. Do not reuse gaskets, O-rings or seals during reassembly.Р”В®NGINE AND TRANSMISSION, REMOVAL AND INSTALLATION.As an aid to installation, label all components, wires, and hoses before removing them.Cover rear fender surfaces and painted areas surrounding engine bay before beginning removal procedure.The jack adaptors allow the rear of the engine to pivot down and the engine/transmission assembly to be pulled out from the rear of the vehicle.Р”Вue to risk of personal injury, be sure the engine is cold before beginning the removal procedure. ^ For an alternate removal procedure, some special jack adaptors are recommended to support the engine/transmission assembly. The complete engine with transmission weighs approximately 600 lbs. Support the engine/transmission from below using a heavy duty rolling cart. Removal and installation of the engine/transmission assembly is best accomplished by raising the car on an automotive lift. The complete engine/transmission assembly is removed as a single unit through the bottom of the engine bay. This repair group covers engine removal and installation. Transmission mount, replacing ( G50 transmission-1987-1989) 101-17 GENERAL ** Important information about the all-electric Porsche models can be found here.Engine/transmission, separating and rejoining 101-15Р”В®ngine mount, removing and installing 101-16 Extra features and accessories (attachments, tyre formats, etc.) can change relevant vehicle parameters such as weight, rolling resistance and aerodynamics and, in addition to weather and traffic conditions, as well as individual handling, can affect the fuel/electricity consumption, COРІвЂљвЂљ emissions and performance values of a car. They are intended solely as a means of comparing different types of vehicle. To the extent that NEDC values are given as ranges, these do not relate to a single, individual car and do not constitute part of the offer. As far as new cars (which are type approved in accordance with the WLTP) are concerned, the NEDC values will, therefore, be derived from the WLTP values during the transition period. The additional reporting of the WLTP values is voluntary until their obligatory use. You can find more information on the difference between WLTP and NEDC at Currently, we are still obliged to provide the NEDC values, regardless of the type approval process used. This may lead to corresponding changes in vehicle taxation from 1 September 2018. Due to the more realistic test conditions, the fuel/electricity consumption and COРІвЂљвЂљ emission values determined in accordance with the WLTP will, in many cases, be higher than those determined in accordance with the NEDC. As of 1 September 2018 the WLTP replaced the New European Driving Cycle (NEDC). Since 1 September 2017 certain new cars have been type approved in accordance with the Worldwide Harmonised Light Vehicles Test Procedure (WLTP), a more realistic test procedure to measure fuel/electricity consumption and COРІвЂљвЂљ emissions. * Data determined in accordance with the measurement method required by law.

Porsche 911 engine removal